T15-KL Knife Soldering Tip 4.7mm /45° x 11mm
, , , , ,

T15-KL Knife Soldering Tip 4.7mm /45° x 11mm

SKU: HT15-KL

Hakko
Availability:

In stock

T15 Series Tip For use with the FM2027 / FM2028 Soldering Irons

£17.75 Excl. VAT

In stock

A minimum sub total of £250.00 is required, You need an additional £250.00 to proceed through to the checkout.

For customers in the Republic of Ireland, please contact us for a quote including shipping and customs charges.

Request quote
How to use Shape K and examples

This type has a shape like a knife and is capable of soldering by applying the tip in 3 ways: line, face and point. It is used for soldering at narrow pitches, correction of bridging and drag soldering.

Soldering tiny chip parts such as 0603

Soldering tiny chip parts such as 0603

Put the tip to the leads while laying down the entire blade.
* Soldering tip in the picture is T30-KU with an N2 system iron for pre-heating effect.

Some IC is specified by manufacturer not to be touched electrode by tip end.

The other tip shapes are recommended.
Soldering tiny chip parts such as 0603

Drag soldering

Use it for drag soldering.

PTH

Put the tip to the leads while laying down the entire blade and drag it slowly.

Apply flux to leads and land pads before soldering. It prevents the troubles such as solder bridge.

* Lay the blade down to thoroughly transfer sufficient heat to the pattern.
* Lay the blade down to thoroughly transfer sufficient heat to the pattern.

Use it for drag soldering.

QFP

Put the tip to the leads while laying down the entire blade and drag it slowly.

Apply flux to leads and land pads before soldering. It prevents the troubles such as solder bridge.

* Lay the blade down to thoroughly transfer sufficient heat to the pattern.
* Lay the blade down to thoroughly transfer sufficient heat to the pattern.

Correcting Bridging

Use it for correcting Bridging.

If the bridge amount is small

Stand the blade on edge and drag the tip slowly.

Please operate with clean tip.

* Do not stand the blade up at too steep angle. Doing so will damage the P.W.B.
Drag the tip as shallow as possible against the P.W.B.

Use it for correcting Bridging.

If the bridge amount is large

Lay the blade down and drag the tip slowly.

Please operate with clean tip.

Soldering at the narrow pitches

Use it for soldering at the narrow pitches.

Stand the blade on edge and put the tip end on the leads of the IC chip.

ZoomViewing from the front also shows that the tip end does not come in contact with the IC.
Categories: , , , , , Tags: , , , , , , ,