T19-C4 Bevel Soldering Tip 4mm/45° x 18.5mm

When the tip is placed, solder left in a hollow section absorbs solder in the bridge section.
Please use this shape if solder amount of the bridge is small.
* If solder amount of the bridge is large, Shape J, K and H are recommended. For further details, see the Correcting Bridging

Prevents bridging from occurring when drag soldering;

Since the pulling force due to surface tension of this type is stronger than that of Shape BC, solder is not left in unnecessary areas during drag soldering.

Apply flux to leads and land pads before soldering. It prevents the troubles such as solder bridge.

See the movie for further details,

A small amount of solder may be left in the hollow section.

2. Put the tip on the bridge section and drag it.

Put the hollowed surface on the bridge section