T39-D08 Soldering Iron Tip - Chisel
, , ,

T39-D08 Soldering Iron Tip – Chisel

SKU: HT39-D08

Availability:

In stock

Hakko soldering iron tip used with the FX9701 / FX9702 soldering iron used with the FX971 and FX972 Soldering Stations
T39 Composite Tip design includes the sensor within the tip allowing for faster more accurate thermal adjustments and greater stability.

£14.54 Excl. VAT

In stock

A minimum sub total of £250.00 is required, You need an additional £250.00 to proceed through to the checkout.

For customers in the Republic of Ireland, please contact us for a quote including shipping and customs charges.

Request quote
How to use Shape D and examples

This shape is capable of any soldering by placing the tip end in 2 ways: line and face. Therefore it requires soldering skill such as Shape B.

Tip Shape DLine example
Line example

Shape D is also available for soldering at narrow pitches by placing the tip end in Line.
T12 series has ten kinds of Shape D which has the variation of Line width from 0.5mm to 1.2mm.

Soldering tiny chip parts such as 0603
Soldering tiny chip parts such as 0603Put the tip end to the land.
* Soldering tip in the picture is T30-D06 with an N2 system iron for pre-heating effect.

Some IC is specified by manufacturer not to be touched electrode by tip end.

 

The other tip shapes are recommended.
Soldering tiny chip parts such as 0603

Soldering chip parts
Use it for soldering chip part.Put the tip end to the land and drag the tip slowly while feeding solder.

Some IC is specified by manufacturer not to be touched electrode by tip end.

The other tip shapes are recommended.
Soldering chip parts

Drag soldering
Use it for drag soldering.Put the tip end to the leads and drag it slowly.

Apply flux to leads and land pads before soldering. It prevents the troubles such as solder bridge.

 

Check the right timing to feed solder.

The other tip shapes are recommended.
Drag soldering

Pre-tinning lead wire
Use it for pre-tinning lead wire.Put the cut surface to the lead and drag the tip slowly while feeding solder.
Point soldering
Use it for point soldering.PTH

1.Put the tip end to the land pad and PTH at one time to heat them.
2.Feed solder to form smooth fillet on the land pad.
Use it for point soldering.QFP

Put the tip end to the leads and drag it slowly.

The other tip shapes are recommended.
Point soldering

Soldering cup terminals
Use it for soldering cup terminals.
1.Put the cut surface to the lead and terminal at one time to heat them.
2.Feed solder to form smooth fillets.

Get rid of gold plating of terminal and pre-tin lead wire. It makes solder spread over the terminal
easily and prevents soldering defect. For further information, see Soldering cup terminals.

Melting and removing coil coatings
Use it for melting and removing coil coatings.
1.Put the cut surface to the coil and terminal at one time to heat them.
2.Feed solder.

The other tip shapes are recommended.
Melting and removing coil coatings

Categories: , , ,